HTG-300 PARTS Drawings and Hydraulics

(NOTE: This manual is different the 400 manual we listed. Same amount of pages and explanation but different.)

26  drawings

28 Pages Total

The drawings include part numbers for bearings

These include…

* Work Head 2 drawings ( round cast head )

* Grinding spindle

* Lead spindle

* Mounting plate in back holding hydraulic switches

* Hydraulic switches (commanding blocks)

* Schematic of Hydraulic switches, to the controls and the electrical involved and the rest of the Hydraulic section

(this one is different then the drawing that comes with the operators manual)

* Hydraulic Schematic ( the same as the operators manual)

* Table cylinder

*Table reversal (the parts behind the control panel)

* Handwheel spindle

* Cross Slide

* Lubrication Drawing (show the piping, and where it goes)

* Coolant system, nozzles etc.

* Tailstock, Diamond holder

AND * Internal grinder attachment